3Com Switch 8800 Configuration Guide Chapter 46 System Maintenance and Debugging46-16Every channel has been set with a default record, whose module name is default andthe module number is 0xffff0000. However, for different channels, the default recordmay have different default settings of log, trap and debugging. When there is nospecific configuration record for a module in the channel, use the default one.Note:If you want to view the debugging information of some modules on the switch, you mustselect debugging as the information type when configuring information source,meantime using the debugging command to turn on the debugging switch of thosemodules.You can use the following commands to configure log information, debugginginformation and the time-stamp output format of trap information. This configuration willaffect the timestamp of the displayed information.Perform the following configuration in system view:Table 46-23 Configure the output format of time-stampOperation CommandConfigure the output format of thetime-stampinfo-center timestamp { log | trap |debugging } { boot | date | none }Output time-stamp is disabled undo info-center timestamp { log |trap | debugging }4) Configuring the loghostThe configuration on the loghost must be the same with that on the switch. For relatedconfiguration, see the configuration examples in the later part.46.5.4 Sending the Configuration Information to Console terminalTo send configuration information to console terminal, follow the steps below:1) Enabling info-centerPerform the following configuration in system view.Table 46-24 Enable/disable info-centerOperation CommandEnable info-center info-center enableDisable info-center undo info-center enable
