3Com Switch 8800 Configuration Guide Chapter 46 System Maintenance and Debugging46-23modu-name specifies the module name; default represents all the modules; allrepresents all the information filter configuration in channelnum chunnel except default;level refers to the severity levels; severity specifies the severity level of information.The information with the level below it will not be output. channel-number specifies thechannel number and channel-name specifies the channel name.When defining the information sent to log buffer, channel-number or channel-namemust be set to the channel that corresponds to logbuffer direction.Every channel has been set with a default record, whose module name is default andthe module number is 0xffff0000. However, for different channels, the default recordmay have different default settings of log, trap and debugging. When there is nospecific configuration record for a module in the channel, use the default one.Note:If you want to view the debugging information of some modules on the switch, you mustselect debugging as the information type when configuring information source,meantime using the debugging command to turn on the debugging switch of thosemodules.You can use the following commands to configure log information, debugginginformation and the time-stamp output format of trap information.Perform the following configuration in system view:Table 46-37 Configure the output format of time-stampOperation CommandConfigure the output format of thetime-stampinfo-center timestamp { log | trap |debugging } { boot | date | none }Output time-stamp is disabled undo info-center timestamp { log |trap | debugging }46.5.7 Sending the Configuration Information to the Trap BufferTo send configuration information to the trap buffer, follow the steps below:1) Enabling info-centerPerform the following configuration in system view.Table 46-38 Enable/disable info-centerOperation CommandEnable info-center info-center enable
