3Com Switch 8800 Configuration Guide Chapter 7 Link Aggregation Configuration7-97.3 Displaying and Debugging Link AggregationAfter the above configuration, execute the display command in any view to display therunning of the link aggregation configuration, and to verify the effect of theconfiguration.In user view, execute the reset command to clear statistics on the LACP-enabled port,and the debugging command to enable LACP debugging.Table 7-7 Display and debug link aggregationOperation CommandDisplay summary information of allaggregation groups display link-aggregation summaryDisplay detailed information of a specificaggregation groupdisplay link-aggregation verboseagg-idDisplay the local device ID display lacp system-idDisplay detailed link aggregationinformation at the portdisplay link-aggregation interface{ interface-type interface-number |interface-name } [ to { interface-typeinterface-num | interface-name } ]Clear LACP statistics on the portreset lacp statistics [ interface{ interface-type interface-number |interface-name } [ to { interface-typeinterface-num | interface-name } ] ]Disable/enable LACP state debugging[ undo ] debugging lacp state[ interface { interface-typeinterface-number | interface-name } [ to{ interface-type interface-num |interface-name } ] ] { { actor-churn |mux | partner-churn | ptx | rx }* | all }Disable/enable LACP packet debugging[ undo ] debugging lacp packet[ interface { interface-typeinterface-number | interface-name } [ to{ interface-type interface-num |interface-name } ] ]Disable/enable link aggregation errordebugging[ undo ] debugging link-aggregationerrorDisable/enable link aggregation eventdebugging[ undo ] debugging link-aggregationevent
