3Com Switch 8800 Configuration Guide Chapter 47 SNMP Configuration47-947.4 Displaying and Debugging SNMPAfter the above configuration, execute the display command in any view to display therunning of the SNMP configuration, and to verify the effect of the configuration.Table 47-14 Display and debug SNMPOperation CommandDisplay the statistics information aboutSNMP packets display snmp-agent statisticsDisplay the engine ID of the activedevicedisplay snmp-agent { local-engineid |remote-engineid }Display the group name, the securitymode, the states for all types of views,and the storage mode of each group ofthe switch.display snmp-agent group[ group-name ]Display SNMP user information in thegroup user tabledisplay snmp-agent usm-user[ engineid engineid | group groupname| username username ]*Display the current community name display snmp-agent community[ read | write ]Display the current MIB viewdisplay snmp-agent mib-view[ exclude | include | { viewnamemib-view } ]Display the contact character strings,location character strings, and theSNMP version of the systemdisplay snmp-agent sys-info [ contact| location | version ]*47.5 SNMP Configuration ExampleI. Network requirementsNetwork Management Station and the Ethernet switch are connected through theEthernet. The IP address of Network Management Station is 129.102.149.23 and thatof the VLAN interface on the switch is 129.102.0.1. Perform the following configurationson the switch: setting the community name and access authority, administrator ID,contact and switch location, and enabling the switch to send trap packets.
