112 C HAPTER 4: W ORKING W ITH THE C OMMAND LINE I NTERFACE2 Enter the number of a port on the Switch unit. If the port selected isworking in VLT mode the display will show the port as being a member ofall current VLANs with Tagging shown as vlt.The port information for the Switch is displayed as shown in the examplebelow.Setting the SpanningTree Path CostYou can set the spanning tree path cost on a port of the current Switchusing the stpCost command on the Port menu.To set the spanning tree path cost:1 At the Top-level menu, enter:bridge port stpCostThe following prompt is displayed:Select bridge port (1-12):2 Enter the number of the port.The following prompt is displayed:Enter new value (1-65535) [10]:3 Enter the new value for the spanning tree path cost on the port.Enabling andDisabling SpanningTree Fast StartYou can enable or disable spanning tree fast start on a port of the currentSwitch unit using the stpFastStart command on the Port menu.To enable or disable spanning tree fast start:1 At the Top-level menu, enter:bridge port stpFastStartThe following prompt is displayed:Select bridge ports (1-12) [1]:Unit 2, Port 1 Detailed InformationState: Disabled fwdTransitions: 0StpCost: 19 BroadcastStormControl: EnabledVLAN MembershipVLAN ID Local ID Vlan Name Tagging-----------------------------------------------------------1 1 Default VLAN NoneSelect menu option:
