66 C HAPTER 3: W ORKING W ITH THE W EB INTERFACE802.1Q VLAN Learning Stack Default / DisabledAllows you to specify whether the port uses IEEE 802.1Q learning (GVRP)to place ports in VLANs automatically: Stack Default — The port takes the 802.1Q VLAN learning settingfrom the Advanced Stack Setup page. For more information, see“Configuring the Advanced Stack Settings” on page 76. Disable — The port does not use IEEE 802.Q learning. Use this settingif the device at the other end of the link does not support IEEE802.1Q.If 802.1Q VLAN learning is enabled, the settings of the FWD UnknownTag listbox change — see the FWD Unknown Tag listbox description onpage 64 for more information.For more information about IEEE 802.1Q VLAN learning, see “Using IEEE802.1Q Learning” on page 167.Configuring theConsole PortBy default, the console port is configured for direct connection to aterminal. You only need to change this configuration if you areconnecting a modem to the port. You can configure the console port ofthe Switch using the Console Port Configuration page.To access the page:1 Click the Unit icon on the side-bar.2 Click the console port on the Switch graphic. The Console PortConfiguration page is displayed as shown in Figure 12.Figure 12 The Console Port Configuration page
