Parameters 736ParametersWhat this chapter containsThe chapter describes the parameters, including actual signals, of the controlprogram.Terms and abbreviationsTerm DefinitionActual signal Type of parameter that is the result of a measurement or calculation bythe drive, or contains status information. Most actual signals are read-only, but some (especially counter-type actual signals) can be reset.Def (In the following table, shown on the same row as the parameter name)The default value of a parameter for the Factory macro. For informationon macro-specific parameter values, see chapter Application macros(page 57).FbEq16 (In the following table, shown on the same row as the parameter range,or for each selection)16-bit fieldbus equivalent: The scaling between the value shown on thepanel and the integer used in fieldbus communication when a 16-bit valueis selected in parameter group 52 FBA A data in or 53 FBA A data out.A dash (-) indicates that the parameter is not accessible in 16-bit format.The corresponding 32-bit scalings are listed in chapter Additionalparameter data (page 225).Other [bit] The value is taken from a specific bit in another parameter. The source isselected from a parameter list.Parameter Either an user-adjustable operating instruction for the drive, or an actualsignal.p.u. Per unit
