6 Reference information6.4. Screw joints2533HAC027309-001 Revision: D© Copyright 2006-2010 ABB. All rights reserved.6.4. Screw jointsGeneralThis section details how to tighten the various types of screw joints on the robot.The instructions and torque values are valid for screw joints comprised of metallic materialsand do not apply to soft or brittle materials.UNBRAKO screwsUNBRAKO is a special type of screw recommended by ABB for certain screw joints. Itfeatures special surface treatment (Gleitmo as described below) and is extremely resistant tofatigue.Whenever used, this is specified in the instructions, and in such cases, no other type ofreplacement screw is allowed. Using other types of screws will void any warranty and maypotentially cause serious damage or injury.Gleitmo treated screwsGleitmo is a special surface treatment to reduce the friction when tightening the screw joint.Screws treated with Gleitmo may be reused 3-4 times before the coating disappears. After thisthe screw must be discarded and replaced with a new one.When handling screws treated with Gleitmo, protective gloves of nitrile rubber type shouldbe used.Screws lubricated in other waysScrews lubricated with Molycote 1000 should only be used when specified in the repair,maintenance or installation procedure descriptions.In such cases, proceed as follows:1. Apply lubricant to the screw thread.2. Apply lubricant between the plain washer and screw head.3. Screw dimensions of M8 or larger must be tightened with a torque wrench. Screwdimensions of M6 or smaller may be tightened without a torque wrenchif this is doneby trained and qualified personnel..Lubricant Art. no.Molycote 1000 (molybdenum disulphide grease) 11712016-618Continues on next page
