ADT Safewatch Pro 3000 Installaton Manual

Also see for SafeWatch 3000: User guide BATTERY REPLACEMENT INSTRUCTIONS Programming guide

Contents

ADT Safewatch Pro 3000 Installaton Manual Manual pdf 18 page image

Safewatch Pro 3000 Installation Instructions2-10Connecting Relay Modules1. Mount either remotely or in the control panel.2. Connect to control’s touchpad terminals using theconnector harness supplied with the module. Usestandard 4-conductor twisted cable for long wiringruns.3. Set each module’s device address according to thetable at right.4. Connect the desired field wiring to the unit's relaycontact terminals.Notes• Use 4204 or 4229 modules.• Supervision: 4204 and 4229 modules aresupervised against removal. The module’s deviceaddress is displayed as follows if a module isdisconnected from the control’s terminals, or ifthe module cover is removed and the tamperjumper is installed:Alpha: CHECK xx Wire ExpansionFAULT xx Wire ExpansionALARM xx Wire ExpansionFixed-Glass: lxx (or 91 if field *199 set for 2-digitdisplay)where “xx is the module’s address.• If communication failure occurs on a device withzones wired to it, all zones on the device will bedisplayed in their respective partitions.4204 Address 4229 Addressno. 1 12 no. 1 (zn 09-16) 07no. 2 13 no. 2 (zn 17-24) 08no. 3 14 no. 3 (zn 25-32) 09no. 4 15 no. 4 (zn 33-40) 10no. 5 (zn 41-48) 1113 14 15 16CNCNODIP SWITCHFOR SETTING DEVICE ADDRESSAND ENABLING/DISABLING TAMPERCOVER TAMPER (REED) SWITCHTB14204TB24-PIN CONSOLE PLUG121110987654321CNCNOCNCNOCNCNORELAY3RELAY2RELAY1RELAY 4TYPICAL(SHOWN "OFF")EITHER OR BOTHCAN BE USEDDATA INFROM CONTROL(–) GROUNDDATA OUTTO CONTROL(+) 12VYELBLKGRNRED4204Figure 11. 4204 Connections to Control(4229 Module is shown in the 4219/4229 Expansion Zones paragraph on page 2-7)