ADT Safewatch Pro 3000 Installaton Manual

Also see for SafeWatch 3000: User guide BATTERY REPLACEMENT INSTRUCTIONS Programming guide

Contents

ADT Safewatch Pro 3000 Installaton Manual Manual pdf 46 page image

Safewatch Pro 3000 Installation Instructions5-6To Enter and Duplicate Wireless KeysThis procedure programs the wireless keys, but a key is not active until it is assigned to a user number (see SystemOperation section, assigning attributes command).If the D key was previously pressed (from *58 Menu mode) to enter and duplicate 5804 and/or 5804BD wirelesskeys, the following screens appear.PROMPT VALID ENTRIES EXPLANATIONTEMPLATE ?1–6 1Template Number1–3 = 5804 templates4–6 = 5804BD templates[∗] to continue1. Enter Template number 1–6 (from next page).See the defaults provided for each template in the chart thatfollows these procedures.2. Select from templates. Press [Q] to display template (1 shownselected). NOTE: If necessary, press [#] to back up and re-entertemplate number.3. Press [#] if you want to return to zone attributes screen.L 01 02 03 04T 23 22 21 23Template Display[∗] to continue4. When [Q] is pressed, the selected template will be displayed.Top line of display represents loop numbers, bottom linerepresents zone type assigned for each zone.5. Press [Q] to accept template.PARTITION1Partition1 = partition 12 = parition 23 = common partition[∗] to continue6. Enter the partition in which the key is to be active.7. Press [∗] to continue.ENTER START ZONE00 = QUIT 36Start Zone Number[∗] to continue8. The system will search for the highest available consecutive 4-zone group (the four zones in the case of the 5804 and 5804BD),and display the lowest zone number of the group.If you want to start at a different zone, enter the zone desired,and press [Q]. If that zone number is displayed, the system hasthe required number of consecutive zones available, beginningwith the zone you entered. If not, the system will again display asuggested zone that can be used.If the required number of consecutive zones is not available at all,the system will display “00”.9. Press [Q] to accept.INPUT S/N LAXXX-XXXX –Serial Number[∗] to continue10. Manually enter the serial number printed on the label for thewireless key or press and release the button to transmit its serialnumber.11. Press [Q] to accept the serial number. The system will check forduplicate.12. If necessary, press the [#] key to back up without saving, and re-enter the serial number.Use the [A] key to move forward within the screen, and the [B] key tomove backward.XMIT TO CONFIRMPRESS Q TO SKIPConfirm[∗] to continue13. If “Yes” was entered at the SET TO CONFIRM? promptpreviously (see first prompt following entry into the Q58 ExpertProgramming Mode), the display on the left will appear. Confirmserial and loop numbers by activating the wireless key.IMPORTANT:When confirmed, the key is not active until it is assigned to a usernumber (using the assigning attributes command, attribute “4”). SeeSystem Operation section for procedure.