|
MX2800 STS-1 User Manual Transaction Language 1 (TL1), Section 9TL1 Commands61204659L1-1A 9-5The MX2800 STS-1 specifically uses “quoted line(s)” in REPT-ALM and REPT-EVT autonomousmessages. The REPT-ALM message has the following quoted line format::,,,,,…The NTFCNCDE field will contain one of the following values:• CL - Alarm Cleared• TC - Transient Condition• MN - Minor• MJ - Major• CR - CriticalThe REPT-EVT message has the following quoted line format:,,,,…The CONDEFF field will contain one of the following values:• CL - Standing Condition Cleared• SC - Standing Condition Raised• TC - Transient ConditionFor possible CONDTYPE codes for both REPT-ALM and REPT-EVT quoted lines, refer to the conditiontypes listed in Table 9-3 on page 11 and Table 9-4 on page 14, respectively.Refer to TL1 Autonomous Messages on page 9-11 for a list of autonomous messages currently supportedby the MX2800 STS-1.4. TL1 COMMANDSAs stated in TL1 Messages on page 9-3, the general format for a TL1 command is:[-[-]]:::::block>: block>;Areas of concentration for TL1 support in the MX2800 STS-1 include session initiation, termination, useraccount management, and system event reporting. Table 9-2 lists the commands currently supported by theMX2800 STS-1.NOTEThe Target ID (TID) is the same as the MX2800 Unit ID. (Refer to theVT100 menus: Configuration/System Management/EquipmentIdentification).
|
