11-3Duralink64 Port Aggregation for NetWareInstalling the NetWare Port AggregationDriverIf you are installing NetWare 4.x on a new server, do not add theDuraLAN NIC at this time. When prompted to add the NIC, selectNo, and then continue with the NetWare installation.If you are installing NetWare 5.0 on a new server, please see Install ofDuralink64 Driver during NetWare 5.0 Operating System Installation onpage 9-3.Note: This driver uses 32 receive buffers for each port.Therefore, if you are using multiple ports, the number ofreceive buffers must be increased.Type load edit c:\nwserver\startup.ncf, and then insert thefollowing commands at the end of the file:SET MINIMUM PACKET RECEIVE BUFFERS = 512SET MAXIMUM PACKET RECEIVE BUFFERS = 1024To install the Port Aggregation driver for NetWare follow thesesteps:1 Insert the Duralink64 Driver for NetWare 4.x/5.0 diskette.2 At the system prompt, type: a:\nwserver\setupsf3 Press Enter. The Select Driver window appears.Figure 11-1. The Select Driver Window4 Select Port Aggregation/FEC and press Enter.5 In the message indicating the New Adaptec NICs have beendetected, press Enter.6 Continue to Configuring Ports on page 11-4.
