2-5Installing Your AdapterPCI Ethernet and Fast Ethernet Adapters User’s GuideStock Number: 511472-00, Rev. A Page: 2-5Print Spec Number: 496708-00Current Date: 5/5/97 ECN Date: 5/97Testing the PCI ConfigurationUseEMDIAG to make sure the PCI adapter is configured properly.For more information aboutEMDIAG, see Chapter 5, Using EMDIAGto Troubleshoot Problems.1 Type A:\EMDIAG and press Enter to start the Adaptec setupprogram.2 At the Main Menu, select Configuration Status.3 The Configuration Status screen reports the resources in use bythe adapter.If the adapter has encountered a resource conflictwith another adapter, or is not yet fully configured,EMDIAGdisplays an error message.Try repeating the installation and configuration proceduresagain. If you still have difficulties, refer to Chapter 5, UsingEMDIAG to Troubleshoot Problems.Testing the Quartet ConfigurationIf you are planning to use your quartet with Windows NT you mustfirst determine if your system's BIOS supports the PCI-to-PCIbridge chip.1 AtEMDIAG's Main Menu, select PCI Device Information.A screen similar to the following appears:
