4-9Installing Network DriversPCI Ethernet and Fast Ethernet Adapters User’s GuideStock Number: 511472-00, Rev. A Page: 4-9Print Spec Number: 496708-00Current Date: 5/5/97 ECN Date: 5/97DOS ODINote: Consult the \readme\dosodi.txt file for the latest driverinformation and installation instructions. Some proceduresor information may have changed or may not have beenavailable when this user’s guide was printed.The following is a partial list of products supported by the DOS ODIdriver:n Novell NetWare 286 Clientn Novell NetWare 3.1x Clientn NetWare 4.x DOS Requester (VLM)n Novell Personal NetWaren Novell LAN WorkPlace for DOSn Windows for WorkgroupsThe DOS ODI driver is compatible with DOS memory managerssuch as EMM386 and can be loaded into high memory. In addition,the driver is compatible with Windows 3.0 and later.Automated NetWare Client InstallationIf you are using the VLM DOS Requester, you can run the auto-mated NetWare Client Install that comes with NetWare 3.x:1 RunInstall from your Novell client install diskette.2 At Step 4 during the install process, remove the Novell clientinstall diskette and insert your Adaptec diskette, specifying\dosodi as the directory location for your adapter driver.Manual InstallationTo install the DOS ODI driver manually, follow these instructions:1 Insert the Adaptec setup diskette into drive A.2 Copy the\dosodi directory on the Adaptec setup diskette intoyour workstation's NetWare directory (usually called\nwclient)
