4-30PCI Ethernet and Fast Ethernet AdaptersPCI Ethernet and Fast Ethernet Adapters User’s GuideStock Number: 511472-00, Rev. A Page: 4-30Print Spec Number: 496708-00Current Date: 5/5/97 ECN Date: 5/97SCO Unixware SMPThe ANA-6944A/TX, ANA-6901A, and the ANA-6911A/TX UNIXdrivers support SCOInstalling the Drivers1 Insert the Unix Drivers diskette into the first floppy drive(usually A).2 Make a directory for the driver, as follows:mkdir adaptec3 Change to the directory you just created, as follows:chdir adaptec4 Copy the files from the floppy diskette to the hard disk, asfollows:doscp a:\unixware\*.*.5 Extract the files, as follows:tar -xvf -d adaptec\empci.tar6 To install the drivers, type:./InstallThe system loads theEMPCI modules and displays the followingmessages:ADAPTEC: Adaptec (10/100) PCI Fast EthernetInstallationADAPTEC: Please Enter the Card you are Installing (1/2)1. Adaptec ANA-6911A PCI EM1102. Adaptec ANA-6944A PCI EM44007 Enter the number (1 or 2, as shown above) of the adapter youare installing. The system displays the following messages:ADAPTEC: NetinfoEMPCI_0EMPCI_1EMPCI_2EMPCI_3ADAPTEC: Please use /etc/confnet.d/configure -i to configure the IP ad-dress
