4-15Installing Network DriversPCI Ethernet and Fast Ethernet Adapters User’s GuideStock Number: 511472-00, Rev. A Page: 4-15Print Spec Number: 496708-00Current Date: 5/5/97 ECN Date: 5/97Note: If no drivers are currently installed for Adaptec orCogent PCI adapters, skip to step 13.Remove Existing Adaptec Ethernet Drivers6 Click the Adapters tab in the Network dialog box.7 To remove any currently installed Adaptec or Cogent PCIadapters highlighting the adapter, click Remove, then click onOK. Repeat until all Adaptec or Cogent PCI adapter driversare removed.8 Click Close to close the Network dialog box.9 Click Yes to restart your computer.Note: When you restart Windows NT, a message mayindicate that at least one service failed to start. This messagewill not appear after you add the new Duralink drivers inthe following steps. Click OK.Adding Duralink Drivers10 Double-click the My Computer icon.11 Double-click the Control Panel icon.12 Double-click the Network Setup icon.13 Click the Adapters tab in the Network Setup dialog box.Note: Do not allow Network Setup to autodetect thenetwork adapter.14 Click Add.15 Click Have Disk.16 At the prompt Insert disk with software provided by thesoftware or hardware manufacturer, insert the disk with theDuralink failover driver. Enter the path to the directory wherethe driver and OEMSETUP file are located. Click OK.
