4-14PCI Ethernet and Fast Ethernet AdaptersPCI Ethernet and Fast Ethernet Adapters User’s GuideStock Number: 511472-00, Rev. A Page: 4-14Print Spec Number: 496708-00Current Date: 5/5/97 ECN Date: 5/97Forces the connection to 100 Mb/s in Full Duplex mode.n THINUse this when connecting to the BNC port of a Comboadapter. This is a 10 Mb/s Half Duplex only connection.n THICKUsed for an adapter that uses an AUI port.This is a 10-Mb/s Half Duplex only connection.Note: Be sure to select the appropriate cable type for yournetwork.Click Continue.19 Repeat step 18 for each Adaptec adapter installed in yoursystem. Each adapter can be identified by its unique PCIBus/PCI Slot number.20 If SNMP has not been set up on this computer you will receivethe following setup Message: Install the NT SNMP serviceand use configure option to configure Server related MIBs.Click OK.Installing the Duralink Driver for Windows NT 4.01 Place at least two Adaptec PCI adapters (such asANA-6911A/TX) in the system.Note: To avoid conflicts on the network, do not attach cablesfrom both adapters to a common hub until after the drivershave been configured for failover and the system hasrebooted.2 Boot your system with Windows NT 4.0.3 Double-click the My Computer icon.4 Double-click the Control Panel icon.5 Double-click the Network icon.
