Adaptec PCI Ethernet and Fast Ethernet Adapters User Manual

Also see for ANA-6904: Specifications

Contents

Adaptec PCI Ethernet and Fast Ethernet Adapters User Manual Manual pdf 53 page image

4-25Installing Network DriversPCI Ethernet and Fast Ethernet Adapters User’s GuideStock Number: 511472-00, Rev. A Page: 4-25Print Spec Number: 496708-00Current Date: 5/5/97 ECN Date: 5/97The drivers are now displayed on the list of drivers.4 Click Add to add the drivers.Note: If you added all four ports for theANA-6944A/TX, OS/2 automatically loads as manydrivers as you need when you reboot.5 Select the appropriate protocols and click Add.Note: If you need to configure each port with differentprotocols, pay attention to the order of binding. Thefirst device on your list installs the driver for port 1(the top connector on the card and the furthest fromthe PCI bus connector). The second device loads port 2(next to port 1), and so on.6 Shutdown OS/2 and reboot for your network driver andprotocol(s) to take effect.Installing the Drivers for a Pre-existing OS/2 SMPUse the following instructions if you already have OS/2 SMP orOS/2 Peer Client installed on your machine. If you are installingOS/2 SMP for the first time, see Installing OS/2 SMP for the First Timeon page 4-26.1 On your desktop, double-click the MPTS (Multi-ProtocolTransport Services) icon.2 Select Install.3 Select Install Additional Network Drivers, and specifya:\ndis.os2 as the source. Select OK.4 After the OS/2 driver is copied from the diskette, select OK.5 Select Configure.6 Select LAN Adapters and Protocols and then click Configure.7 In the LAPS dialog box, under Network Adapters, highlightthe ANA-6944A/TX and click Add. Repeat this three times toadd the other three ports as separate devices.