Barco R9002031 Owner's Manual

Also see for R9002031: Installation manual

Contents

Barco R9002031 Owner's Manual Manual pdf 13 page image

Connections3-35975597 BARCODATA 808S 110397Connecting a Composite Video source to port 1.Composite video signals from a VCR, OFF air signal decoder, etc..PORT 4/5See installation instructions b efore connecting to the supply.Voir la not ice d'in stallat ion ava nt de r accorder au rés eau.12 0/2 30 V7/5 Amp50/60 Hz 75 OhmPORT 27 5 Ohm358TV tuner, e.g. TVDM40 stereoVCRAudio amplifierCompositevideo to next projector orto a monitorThis device complies with part 15 ofthe FCC rules. Operation is subject tofollowing two conditions (1). Thisdevice may not cause harmful inter-ference, and (2) this device mustaccept any interference receivedincluding interference that may causeundesired operation"Video input selection :Press digit button 1 on the RCU or the local keypad.* Note : If using the loop-through Video output, then set theTermination Switch to the "OFF" position.Connecting a S-Video or Video source to port 2.Separate Y-luma/C-chroma signals for higher quality playback of Super VHS signals.Highlight Port 2 : Video and press ENTER to toggle between VIDEOor S-VIDEO.Press EXIT to return.Press ADJUST to return to operational mode.PORT 4/5See installation instructions before connectin g to the supply.Voir la no tice d' instal lation avant de rac corder au rés eau.12 0/2 30 V7/5 Amp50/60 Hz 7 5 OhmPORT 27 5 Ohm359VCR S-VHSAudio amplifierLuma/Chromato next projector orto a monitorThis device complies with part 15 ofthe FCC rules. Operation is subject tofollowing two conditions (1). Thisdevice may not cause harmful inter-ference, and (2) this device mustaccept any interference receivedincluding interference that may causeundesired operation"Select with orthen to return.ADJUSTMENT MODESelect a path from below :GUIDEDRANDOM ACCESSINSTALLATIONSERVICEIRISSource 02Select with orthen to return.Choose a setup patternfrom below :SELECTED SOURCEGENLOCKED PATTERNINTERNAL # PATTERNSource 02Select with orthen to return.RANDOM ACCESSADJUSTMENT MODEPICTURE TUNINGGEOMETRYCONVERGENCEFOCUSINGCOLOR SELECTORBITINGCONTR. MODULATIONSOFT EDGESelect with or to accept to return.PICTURE TUNINGCOLOR BALANCESYNC : FASTPORT2 : S-VIDEOLINE DOUBLER : ONHighlight 'Picture Tuning' and press ENTER.Select 'Selected source' and press ENTER.Input selectionPress digit button 2 on the RCU or the local keypad.Depending on the priority setting in the Picture Tuningmenu, Video or S-Video can be displayed.If the setting is not correct, start up the adjustment mode bypushing on th ADJUST key.Select 'Random Access' and press ENTER.* Note: When using the Port 2 loop-through output, set the Termina-tion Switch in the "OFF" position.12344 pin connector configurations:For S-video:Pin 1: earth(ground) luminancePin 2: earth(ground) chrominancePin 3: luminance signal(Y)1Vpp ±3dBPin 4: chrominance signal(C)300mVpp ±3dBFor video:Pin 1: earth(ground) videoPin 2: not connectedPin 3: video signalPin 4: not connected