Service Mode7-55975597 BARCODATA 808s 110397Set to midpositionItem is password protected.Highlight 'set to midposition' with the control disk and press ENTERto set all settings to their midposition.A confirmation menu will be displayed first.Select with orthen to return.SERVICE MODEIDENTIFICATIONCOPY A BLOCKDELTE A BLOCKDELETE ALL BLOCKSCHANGE PASSWORDCHANGE LANGUAGERUN TIMESET TO MIDPOSITIONCONVERGENCE MIDDYNAMIC ASTIGMATISMMORE...SET TO MIDPOSITIONAll settingsin current blockwill be overwritten ! to confirm to cancelENTER will set all settings to their midposition. EXIT will cancel theoperation to set all settings to their midposition.Select with orthen to return.SERVICE MODEIDENTIFICATIONCOPY A BLOCKDELTE A BLOCKDELETE ALL BLOCKSCHANGE PASSWORDCHANGE LANGUAGERUN TIMEUNDO MIDPOSITIONCONVERGENCE MIDDYNAMIC ASTIGMATISMMORE...Undo MidpositionWhen 'Set to Midposition' is selected, all settings are set to theirmidposition. To cancel this action, select 'Undo Midposition' bypushing the control disk up or down and press ENTER. 'UndoMidposition' is displayed in the service mode in stead off 'Set toMidposition' when this latter is pressed.An undo is possible as long as the projector is playing on the samesource (= same adjustment block) even when some adjustments asgeometry or convergence are already readjusted. When undo ispressed all settings are reset to the previous settings.Convergence MidItem is password protected.Highlight 'convergence mid' with the control disk and press ENTERto set all convergence settings to their midposition. A confirmationscreen will be displayed first.Select with orthen to return.SERVICE MODEIDENTIFICATIONCOPY A BLOCKDELTE A BLOCKDELETE ALL BLOCKSCHANGE PASSWORDCHANGE LANGUAGERUN TIMESET TO MIDPOSITIONCONVERGENCE MIDDYNAMIC ASTIGMATISMMORE...CONVERGENCE MIDAll settingsin current blockwill be overwritten ! to confirm to cancelENTER sets the convergence settings to their midposition. EXITcancels the procedure to set the convergence settings to theirmidposition.Undo Convergence Mid(position)When 'Convergence Mid' is activated, all convergence settings areset to their midposition. To cancel this action, select 'Undo Conver-gence Mid' by pushing the control disk up or down and press ENTER.'Undo Convergence Mid' is displayed in the service mode menu instead off 'Convergence Mid' when this latter is activated.An 'undo' is possible :* as long as the projector is operating on the same source (= sameadjustment block) even when some convergence adjustments arealready readjustedAND* 'set to midposition' is not yet selected.Select with orthen to return.SERVICE MODEIDENTIFICATIONCOPY A BLOCKDELTE A BLOCKDELETE ALL BLOCKSCHANGE PASSWORDCHANGE LANGUAGERUN TIMESET TO MIDPOSITIONUNDO CONVERGENCE MIDDYNAMIC ASTIGMATISMMORE...
