Location and Functions of Control2-15975597 BARCODATA 808S 1103972 LOCATION AND FUNCTION OF CONTROLSREAR PANEL TERMINOLOGYPORT 4/5See installation i nstru ction s befo re co nnecting to the supp ly.Voir la notice d'installation avant de raccorder au réseau.120/230 V7/5 Amp50/60 Hz 75 OhmPORT 275 Ohm1 2 3 4 5 76 8 9 10This device complies with part 15 ofthe FCC rules. Oper ation is sub ject tofollowing two cond itions (1). Thisdevice may no t cause h armful inter-feren ce, and (2) this device mustaccept any interf eren ce receivedincluding interference that may causeundesired operation"Power Switch : Press the switch to turn the projector ON.Depending on the hardware set-up of the projector duringinstallation, the projector switches to ‘Standby’ or to ‘Op-erational' mode. If in standby, the standby LED lights up.AC Power InputCommunication Port (800 peripherals)* Allows communication between the RCVDS switcher andthe projector.* Allows connection of a remote IR receiver unit to theprojector.Port 3RGB Analog Input (9 pin female sub D connector). Allowsa character generator, microcomputer, etc. having analogRGB outputs to be connected to the projector.Port 4/5 : RGB-S Input (5x BNC connector):RGB-S input : allows a character generator, microcomputer,video camera, etc. having analog RGB output to be con-nected to the projector.Line inputs: - signals RED-GREEN-BLUE- COMPOSITE sync. signal- Tri level sync signal (option)12S-VIDEO Input: Separated Y/C (luma-chroma) signal in-puts and outputs for higher quality playback of Super VHSsignals (4-pin S-VIDEO connector loop-through).75 ohm Termination Switch for S-Video signalsVIDEO Input (Composite video, 2x loop-through BNCconnector): Allows a video tape recorder, video camera,color receiver/monitor, etc. having video line output to beconnected to the projector.75 ohm Termination Switch for Video signalsProjector Pilot Lamp : Indicates the status of the projector.- Unlit : mains (power) switch is not pressed.- Lit : mains (power) switch is pressed and the indicated colorshows the projector mode:Green color : Operational mode of the projector.Red color : Standby mode of the projector.Important : Projector ("Operational" or "Standby") mode isdefined during the installation of the projector. (Refer to aqualified technician for change).345678910FRONT PANEL TERMINOLOGYRS232 IN RS232 OUT IR REMOTERS232 INRS232 OUTIRREMOTE11 12 13 14RS 232 Input PortConnection between the BARCODATA 808 and an IBM PC(or compatible) or MAC (RS422) for remote computercontrol and data communication.RS 232 Output PortRS 232 Output Port allows a communication link for PC orMAC to the next projector in a series of projector.IR SensorReceiver for control signals transmitted from the RCU.IR RemoteConnector for remote input for hard wired remote control11121314