AW00097603000 Physical InterfaceBasler aviator GigE 375.5 Camera PowerCamera power must be supplied to the 12-pin connector on the camera via a cable from your powersupply. Nominal operating voltage is +12 VDC (± 10%) with less than one percent ripple. Powerconsumption is as shown in the specification tables in Section 1 of this manual.Close proximity to strong magnetic fields should be avoided.5.6 Ethernet GigE Device InformationThe camera uses a standard Ethernet GigE transceiver. The transceiver is fully 100/1000 Base-T802.3 compliant.NOTICEApplying incorrect power can damage the camera.1. The camera’s nominal operating voltage is +12 VDC (± 10 %). If the voltage applied to thecamera is greater than +13.2 VDC, severe damage to the camera can result. If the voltage isless than +10.8 VDC, the camera may operate erratically.2. Make sure that the polarity of the power applied to the camera is correct. Applying power withthe wrong polarity can result in severe damage to the camera.NOTICEAn incorrect plug can damage the camera’s 12-pin connector.The plug on the cable that you attach to the camera’s 12-pin connector must have 12 female pins.Using a plug designed for a smaller or a larger number of pins can damage the connector.
