AW00097603000 Physical InterfaceBasler aviator GigE 415.8 Output Line Description5.8.1 Voltage RequirementsThe following voltage requirements apply to the I/O output VCC (pin 10 of the 12-pin receptacle):5.8.2 CharacteristicsThe camera is equipped with four physical output lines designated as output line 1, output line 2,output line 3, and output line 4. The output lines are accessed via the 12-pin receptacle on the backof the camera.As shown in the I/O schematic, each output line is opto-isolated. See the Voltage Requirementssection for the recommended operating voltage. The maximum current allowed through anoutput circuit is 50 mA.A logical zero on Out X Ctrl results in a non-conducting transistor Q in the Output Line X circuit,where X = the number of an output line. For example, a logical zero on Out 1 Ctrl results in a non-conducting transistor Q in the Output Line 1 circuit.A logical one on Out X Ctrl results in a conducting transistor Q in the Output Line X circuit, where Xequals the number of an output line. For example, a logical one on Out 1 Ctrl results in a conductingtransiator Q in the Output Line 1 circuit.Figure 13 shows a typical circuit you can use to monitor the output line with a voltage signal.Voltage Significance< +3.3 VDC The I/O outputs may operate erratically.+3.3 to +24 VDC Operating voltage.Table 4: Voltage Requirements for the I/O Output VCC
