Chapter 5: Local Management5-702H23-50R/2H33-37R User’s Guide5.19.2 Enabling /Disabling PortsTo enable or disable one or more ports, proceed as follows:1. Use the arrow keys to highlight the CONNECTOR # field.2. Use the SPACE bar to step to the number of the connector containingthe network(s) to be enable or disabled.3. Use the arrow keys to highlight the MODE PORT STAT. field of thenetwork being enabled or disabled.4. Use the SPACE bar to toggle to the appropriate setting (Enabled orDisabled).5. If setting more than one network, repeat steps 3 and 4 for each one andthen proceed to step 6.6. Use the arrow keys to highlight the SAVE command.7. Press ENTER. The message “SAVED OK” displays and all settingsare saved.5.19.3 Setting All PortsAll the network ports on a connector can be set to the same operatingmode simultaneously using the SET ALL PORTS field, as follows:1. Use the arrow keys to highlight the CONNECTOR # field.2. Use the SPACE bar to step to the appropriate connector number.3. Use the arrow keys to highlight the SET ALL PORTS field.4. Use the SPACE bar to step to the appropriate Operating Mode(Auto-Neg, 10Base-T, or 100Base-TX).5. Use the arrow keys to highlight the SAVE command.6. Press ENTER. The message “SAVED OK” displays and all networksof the connector are set to the selected operating mode.
