Chapter 5: Local Management5-462H23-50R/2H33-37R User’s GuideThe following briefly defines each field of the System Resources screen.CPU Type (Read-only)Indicates the microprocessor used in the 2H23-50R or 2H33-37R.Flash Memory Installed (Read-only)Indicates the amount of FLASH memory installed in the 2H23-50R or2H33-37R and how much is currently available.DRAM Installed (Read-only)Indicates the amount of DRAM installed in the 2H23-50R or 2H33-37Rand how much of it is currently available.NVRAM Installed (Read-only)Indicates the amount of NVRAM installed in the 2H23-50R or 2H33-37Rand how much of it is currently available.Current Switch Utilization (Read-only)Shows the percentage of the device switching capacity currently beingused.Peak Switch Utilization (Read-only)Shows the peak percentage of device switching capacity used, since thelast reset.Reset Peak Switch Utilization (Toggle)Enables the user to reset the Peak Switch Utilization field. The switchmay be set to either YES or NO as described in Section 5.12.1. YES resetsthe Peak Switch Utilization field to the current system traffic.5.12.1 Setting the Reset Peak Switch UtilizationTo set the Reset Peak Switch Utilization field to YES or NO, proceed asfollows:1. Use the arrow keys to highlight the Reset Peak Switch Utilizationfield.2. Press the SPACE bar to select YES or NO.3. Use the arrow keys to highlight the SAVE command at the bottom ofthe screen.4. Press ENTER. The message “SAVED OK” displays.
