WAN Configuration Using Local ManagementCSX200 Family User’s Guide 149The following information must be supplied to you by the service provider.LMP type: ANSI T1.617 Annex DThe line configuration information shown in Table 16 must be supplied by the service provider.Frame Relay Physical ConfigurationBegin physical configuration by accessing the WAN Physical Configuration screen through LocalManagement. Proceed with the following steps:1. Use the arrow keys to highlight Time Slot View. Press the SPACEBAR to select New, thenpress ENTER. The cursor moves to Time Slot #1 of the Time Slot Configuration Table.2. Insert an interface number (refer to the NOTE below) into every Time Slot being used. Typethe number, press ENTER, then use the arrow keys to highlight the next Time Slot field. Exitthis field by using the arrow keys. The cursor automatically moves to the T1 Line Coding field.3. Use the arrow keys to highlight T1 Line Coding. Press the SPACEBAR to select B8ZS orAMI, then press ENTER.Table 16 Telco Configuration InformationConfiguration InformationRequired by CustomerInformation Supplied by ServiceProviderLine Coding B8ZS or AMIFrame Type ESF or D4Clock Source Loop Timing or Local TimingDS-0s (Time Slots) Time Slots being used for each end ofthe circuitNOTESThe value assigned to the Time Slots is the interface being used for WANcommunication. The available interface range is displayed on the WAN PhysicalConfiguration screen (see Figure 64). You may insert any of the available interfacenumbers into the Time Slots.In the example shown in Figure 64, the interface range for the CSX200 is 2–25.Although any of these values may be used, Cabletron Systems recommends using thefirst available interface number (in this example interface #2).The following four steps are based on information supplied by the service provider.Consult the service provider for the correct settings.
