InstallationCSX200 Family User’s Guide 291. Attach the disposable grounding strap to your wrist (refer to the instructions outlined on thedisposable grounding strap package).2. Remove the CSX200 cover (refer to Removing the CSX200 Cover for instructions).3. Remove the blank faceplate from the appropriate WAN slot.4. Orient the WPIM as shown in Figure 5.5. Carefully insert the WPIM connector into the WPIM connector pins on the CSX200.6. Press down firmly on the WPIM until the pins slide all the way into the connector. Ensure thatthe WPIM seats flush on the standoffs.7. Secure the WPIM to the three standoffs using the screws.8. Replace the CSX200 cover.CSX200-COMP/ENCR InstallationThis section contains instructions on how to install the CSX200-COMP/ENCR into the CSX200chassis. To help eliminate any potential problems during or after installation, read and understandthe following steps:1. Attach one end of the antistatic wrist strap to your wrist and the other end to an approvedelectrical ground.2. Unpack the CSX200-COMP/ENCR by carefully removing it from the shipping box and thenfrom the protective plastic bag. Do not cut the bag as the device could be damaged. If there areany signs of damage, contact the Cabletron Systems Global Call Center. See the Getting Helpsection of this document.3. Power down the CSX200 before installing the CSX200-COMP/ENCR.4. Remove the chassis cover of the CSX200 to install the CSX200-COMP/ENCR (refer toRemoving the CSX200 Cover, on page 26).!CAUTIONThe CSX200-COMP/ENCR comes with a pre-attached metal cage. Do not removethis cage.
