WAN Configuration Using Local ManagementCSX200 Family User’s Guide 155If you select FR, the following fields display:FR LMP: This field displays NO LMI, Q.933-A or T1.617-D. Set this field toT1.617-D. The NO LMI setting is for specialized applications in which no Frame Relay LinkManagement is available or required.If NO LMI is selected, the following field is displayed:Circuit State: toggles between Active, Inactive and Invalid.DLCI Address: This field can be set to values from 0–1023. The values 0–15 and1008–1022 are reserved DLCI addresses.CKT_DCP Enable:This field indicates whether data compression will take place. Togglesbetween ON and OFF.CKT_DCP Status: This status field displays whether data compression was successful or not.Comp Ratio: This field displays the ratio of uncompressed to compressed transmitteddata.PT# — Displays the application ports (bridge ports) available from the host platform to the WAN.If the active protocol is PPP, Local Management assigns only one application port per interfacenumber (IF#). If the active protocol is Frame Relay, Local Management assigns the available WANbridge ports from the host platform, one per DLCI.The quantity of application ports for a Frame Relay network is determined by the quantity ofDLCIs (Data Link Connection Identifiers) assigned to that Interface. This is determined eithermanually or by the Local Management Interface.IF# — Displays the Interface that is associated with the application port.LID — Displays the Link Identifier. If the active protocol is Frame Relay, the Data LinkConnection Identifier is displayed. If the active protocol for this interface is PPP, then PPP displaysin this field.STATE — Displays the status of the application port. If the active protocol is Frame Relay, thisfield displays the status as Active, Inactive, or Invalid (no LMI). If the active protocol is PPP, thisfield displays UP (active) or DOWN (inactive).
