WAN Configuration Using Local Management150 CSX200 Family User’s Guide4. Use the arrow keys to highlight T1 Frame Type. Press the SPACEBAR to select ESF or D4,then press ENTER.5. Use the arrow keys to highlight T1 Tx Clock Source. Press the SPACEBAR to select Local(no clock source provided by telephone company) or Loop (clock source provided by telephonecompany), then press ENTER.6. Use the arrow keys to highlight T1 Line Buildout (LBO). Press the SPACEBAR to select to0 dB unless the service provider recommends another setting, then press ENTER.7. Use the arrow keys to highlight the SAVE command, then press ENTER. The message “SAVEDONE!” displays and Local Management saves the changes to memory.8. Access the WAN Interface Configuration screen by using the arrow keys to highlight the WANInt Config option, then press ENTER.Frame Relay Interface ConfigurationThis screen is accessed through the WAN Physical Configuration screen. Proceed with thefollowing steps to configure the WAN Interface through Local Management.1. Set the Interface Number that is being used for the WAN connection by typing the same numberinto the Interface Number field that was input into the Time Slots in the WAN PhysicalConfiguration screen, then press ENTER (refer to the NOTE above).2. Use the arrow keys to highlight Line Coding. Press the SPACEBAR to select NONE, thenpress ENTER.3. Use the arrow keys to highlight Active Protocol. Press the SPACEBAR to select FR, thenpress ENTER.4. Use the arrow keys to highlight FR LMP. Press the SPACEBAR to select T1.617-D, then pressENTER.5. Use the arrow keys to highlight CKT_DCP Enable. Press the SPACEBAR to select ON, if youwant data compression enabled or OFF, if you do not, then press ENTER.6. Use the arrow keys to highlight SAVE, then press ENTER. The message “SAVE DONE!”displays and Local Management saves the changes to memory.NOTEIf you are using a Local clock source, set only one end of the circuit for Local, the otherend must be set for Loop.
