APPENDIX A: EPIM INFORMATIONA-2SEHI USER’S GUIDEA.1.2 EPIM-F1 and EPIM-F2The EPIM-F1 and EPIM-F2 shown in Figure A-2 support MultimodeFiber Optic cabling. Each EPIM has an internal Cabletron SystemsFOT-F Fiber Optic Transceiver. The EPIM-F1 is equipped with SMAConnectors and the EPIM-F2 is equipped with ST Connectors.Specifications for the EPIMs are listed below.Figure A-2. EPIM-F1 and EPIM-F2Note: The transmitter power levels and receive sensitivity levels listed arePeak Power Levels after optical overshoot. A Peak Power Meter must beused to correctly compare the values given above to those measured onany particular port. If Power Levels are being measured with an AveragePower Meter, add 3 dBm to the measurement to compare the measuredvalues to the values listed (i.e., -30.5 dBm peak=-33.5 dBm average).Parameter TypicalValueWorstCaseWorstCaseBudgetTypicalBudgetReceiveSensitivity -30.5 dBm -28.0 dBm — —Peak Input Power -7.6 dBm -8.2 dBm — —Transmitter Power50/125 μm fiber -13.0 dBm -15.0 dBm 13.0 dB 17.5 dB62.5/125 μm fiber -10.0 dBm -12.0 dBm 16.0 dB 20.5 dB100/140 μm fiber -7.0 dBm -9.0 dBm 19.0 dB 23.5 dBError Rate Better than 10-101490_301490_31
