APPENDIX A: EPIM INFORMATIONA-4SEHI USER’S GUIDENote: The transmitter power levels given above are Peak Power Levelsafter optical overshoot. Use a Peak Power Meter to correctly compare thevalues given above to those measured on any particular port. To measurepower levels with an Average Power Meter, add 3 dBm to the averagepower measurement to compare the average power values measured to thevalues listed above(i.e. -33.5 dBm average + 3 dB = -30.5 dBm peak).Parameter Typical Minimum MaximumTransmitter PeakWave Length 1300 nm 1270 nm 1330 nmSpectral Width 60 nm - 100 nmRise Time 3.0 ns 2.7 ns 5.0 nsFall Time 2.5 ns 2.2 ns 5.0 nsDuty Cycle 50.1% 49.6% 50.7%Bit Error Rate: Better than 10-10ReceiveSensitivitydBmLess Power More Power-40 -35 -30 -25 -20 -15 -10 -5 0MaximumReceiveInput PowerTransmitter Power*(At 25°C into8.3/125μm fiber)Minimum Sensitivity (-30.0)Typical Sensitivity (-31.0)Maximum Sensitivity (-36.0)Maximum Receive Input (-6.99)Typical Receive Input (-7.5)Minimum Receive Input (-9.72)Maximum Transmit Power (-12.0)Typical Transmit Power (-15.5)Minimum Transmit Power (-21.0)* Transmit Power Typical Power Minimum Power Maximum PowerCoefficient(See Note Below)-0.15dBm/ °C -0.12 dBm/ °C-0.18 dBm/ °C
