Using the FRX4000, FRX6000, and SmartSwitch 1800 Hub View2-4Using the Hub ViewRLP information will only be displayed if the appropriate database record hasbeen configured via console management (see your hardware documentation formore information); for RLPs which have been configured in the database but notyet installed in the chassis, a blue module status will be displayed (see Port andModule Color Codes, below). RLPs which are present in the chassis but whichhave not been configured in the database will not be displayed.For each configured RLP card, eight serial port status boxes will be displayed(four for each of two possible LIC cards); however, serial port status informationwill only be displayed for ports which are physically present (on an installed LICcard) and have been configured in the database. Ports which are present but notconfigured will display a blank status; if no LIC is present, the value [None] willbe displayed under the appropriate LIC title, and the associated ports will alsodisplay a blank status.LAN cards will only be displayed when they are both present and configured, asthey are configured during the initial firmware installation process, and cannot beconfigured unless they are present.Port and Module Color CodesBoth the module index boxes and the port status boxes are color-coded to indicatestatus (see Figure 2-2, below).Figure 2-2. Module and Port Color CodesModule Index boxesPort Statusboxes
