Using the FRX4000, FRX6000, and SmartSwitch 1800 Hub View2-10Monitoring Hub Performance• Open the Frame Relay Backup Group window (described in Chapter 5, FrameRelay Status and Configuration).• Open the IP, IPX, Bridge, and SNA configuration windows (described inChapters 7, 9, 10 and 11).• Open the Voice Configuration windows (described in Chapter 12, VoiceConfiguration).Note that the Device menu does not provide access to all of the applicationswhich are available to the devices; additional applications are available from theModule and Port menus in the Hub View, and some can only be accessed from theicon menu (if you are running under a network management platform) and fromthe command line (if you are running in stand-alone mode). See Chapter 1,Introduction to SPMA for the FRX4000, FRX6000, and SmartSwitch 1800, for acomplete list of applications available to the devices and how to access each one.Clicking mouse button 1 on the Quit button closes all Hub View applicationwindows; any open applications which can also be accessed from the commandline or from the icon menu will remain open.Monitoring Hub PerformanceThe information displayed in the Hub View can give you a quick summary ofdevice activity, status, and configuration. SPMA can also provide further detailsabout hub performance via its three-level menu structure. The Device, Module,and Port menus (Figure 2-5, below) give you control over the hub at three levelsand give you access to the tools, menus, and windows that let you monitorspecific aspects of hub performance, change hub display options, and set someoperating and notification parameters.NOTEYour Device Menu may not display all of the options listed here. Only those protocols andinterface types for which your node has been configured will be listed on the menu.Only the SmartSwitch 1800 will display the Voice Configuration options.
