Configuring Voice Interfaces12-17SmartSwitch 1800 Voice ConfigurationPeer Node NumberThis parameter is not used if the peer node type is a SmartSwitch 1800. Enter anumber 1 to 61 to specify the node number of the remote device.Peer Node PortThis parameter is not used if the peer node type is a SmartSwitch 1800. Enter anumber 1 to 17 to specify the voice port number on the remote device.Local Node NumberThis parameter is not used if the peer node type is a SmartSwitch 1800. Enter anumber 1 to 61 to specify the node number of the local SmartSwitch 1800. Thisnumber must match the Voice Node Number entered in the system-level VoiceParameters window (see Configuring System-Level Voice Parameters,page 12-2). The default value for this parameter is 1.Local Node PortThis parameter is not used if the peer node is a SmartSwitch 1800. Enter a number1 to 17 to specify the voice port number on the local SmartSwitch 1800.Frame Relay RLPEnter the RLP number of the logical interface of this end of the frame relay link.This would always be 0 for RLP0 on the SmartSwitch 1800.Frame Relay PortEnter the port number of the local frame relay port over which Voice will betransmitted. This will be port numbers 0 through 3 on the SmartSwitch 1800.Frame Relay DLCIEnter a number 16 to 991 specifying local frame relay DLCI over which Voice willbe transmitted.Enable FragmentThis parameter is not currently supported and must be set to No.Adding or Modifying Voice InterfacesFirst, access the Voice Interface Config Window (see Configuring VoiceInterfaces, page 12-15).To add a new Voice Interface:1. Enter the configurable values for each interface.2. Click on to add your new entry.To modify an existing entry:1. In the list box, click to select the interface you wish to modify. The selectedentry will be highlighted. (Note that you can only modify one entry at a time.)
