Personalization FeaturesThe following choices are available for programming:Personalization NameThis feature allows you to type in a name that willappear on the DIC display whenever the correspondingremote keyless entry transmitter is used or one ofthe buttons on the driver’s door armrest (1 or 2) ispressed.If a customized name is not programmed, the systemwill show DRIVER 1 or DRIVER 2 to correspond withthe numbers on the back of the remote keylessentry transmitters.To program a name, use the following procedure:1. Enter the Personalization menu following theinstructions listed previously.2. Select the PERSONALIZATION NAME menuitem by pressing the TUNE/SEL knob once.You will see a cursor on the screen.3. Turn the TUNE/SEL knob until you reach thefirst letter you want. The letter will be highlighted.There is a complete alphabet with both upperand lower case letters and the numbers zerothrough nine. Also included are spaces and othernon-letter characters such as the ampersand (&).4. Press the TUNE/SEL knob once to select the letter.The letter will then appear on the display.If you make a mistake, press the CLR button.This will exit the menu. You can then go backinto the menu and edit the name. You can alsopress the TUNE/SEL knob repeatedly to cyclethrough all the characters until you reach thecharacter you wish to change.5. Repeat Steps 3 and 4 until the name you want iscomplete. You can program up to 16 characters.The name you selected is now set. You can either exitthe programming mode by following the instructionslater in this section or program the next feature availableon your vehicle.Configure Display KeysThis feature allows you to customize the functions of thefour soft keys located to the left and right of the audiodisplay. See “Configurable Radio Display Keys”under Radio with CD on page 3-82 for programminginformation.3-67
