Cadillac CT6 Owner Manual (GMNA-Localizing-U.S./Canada-9235592) -2016 - crc - 11/6/15Keys, Doors, and Windows 334. Place the new transmitter intothe transmitter pocket. Thecenter console storage areawill need to be opened.5. Press ENGINE START/STOP.When the transmitter islearned, the DIC display willshow that it is ready to programthe next transmitter.6. Remove the transmitter fromthe transmitter pocket andpress K or Q on thetransmitter.To program additionaltransmitters, repeat Steps 4–6.When all additional transmittersare programmed, press andhold ENGINE START/STOP forapproximately 12 seconds toexit programming mode.7. Put the vehicle key back intothe transmitter.Programming without aRecognized TransmitterIf there are no currently recognizedtransmitters available, follow thisprocedure to program up to eighttransmitters. This feature is notavailable in Canada. This procedurewill take approximately 30 minutesto complete. The vehicle must be offand all transmitters to beprogrammed must be with you.1. Remove the vehicle key fromthe transmitter.2. Remove the key lock cylindercap on the driver door handle.See Door Locks 0 37. Insertthe vehicle key into the keylock cylinder on the driver doorhandle, then turn the keycounterclockwise to the unlockposition five times within10 seconds.The Driver Information Center(DIC) displays REMOTELEARN PENDING,PLEASE WAIT.3. Wait for 10 minutes until theDIC displays PRESS ENGINESTART BUTTON TO LEARNand then press ENGINESTART/STOP.The DIC display will againshow REMOTE LEARNPENDING, PLEASE WAIT.4. Repeat Step 3 two additionaltimes. After the third time allpreviously known transmitterswill no longer work with thevehicle. Remaining transmitterscan be relearned during thenext steps.The DIC display should nowshow READY FOR REMOTE# 1.
