Adding Marks while Recording102NOTES• There may be up to a 0.5 second delay from when you press the button to when the camcorder adds the shotmark. When using the Wi-Fi Remote application, the delay may be longer depending on the conditions of thewireless signal.• When you are using interval recording or frame recording mode, you cannot add shot marks to a clip.• When a clip contains either shot mark, ! will appear next to the clip’s thumbnail in the playback index screen.Adding an $ Mark or % Mark to the Last Clip RecordedAfter recording an important clip, you can add an OK mark ($) or check mark (%) to the clip to flag it and set itapart. When the camcorder is in mode, you can display an index screen that contains only clips with an$ mark or only clips with a % mark (A 126). Furthermore, you can use the $ mark to protect important clips,as clips with an $ mark cannot be deleted.To add an $ mark or % mark to the last clip recorded in mode, you must first set in advance anassignable button to [Add $ Mark] or [Add % Mark].1 Set an assignable button to [Add $ Mark] or [Add % Mark] (A 111).• To add both types of clip marks (to different clips), set one assignable button to [Add $ Mark] and anotherassignable button to [Add % Mark].2 After recording a clip, press the assignable button.• A message indicating the clip mark will appear and the selected clip mark will be added to the clip.Remote Operation Using Wi-Fi RemoteAfter completing the necessary preparations (A 49), you can set an $ mark or a % mark remotely from aWi-Fi-enabled device using the Wi-Fi Remote application.1 After recording a clip, press [$ MARK] on the Wi-Fi Remote screen to set a an $ mark or[% MARK] to set a % mark.• [OK Mark] or [Check Mark] will be displayed on the Wi-Fi Remote screen and the mark will be applied to theclip.2 Press to close the message.NOTES• A clip cannot have both an $ mark and a % mark at the same time.COPY
