Preparing the Camcorder40Using a TripodThe camcorder is shipped with the TB-1 Tripod Base for tripods with 0.95 cm (3/8 in.)screws. You can mount the camcorder on a tripod but do not use tripods with mountingscrews longer than 5.5 mm (0.2 in.) as this may cause damage to the camcorder.Using a Tripod with 0.64 cm (1/4 in.) MountingScrewsTo use a tripod with 0.64 cm (1/4 in.) mounting screws, firstattach the supplied tripod adapter base to the camcorder andthen attach the tripod to the adapter base.1 Remove the original TB-1 tripod base from the camcorder.• Remove the 4 screws and then remove the base.2 Attach the supplied tripod adapter base for 0.64 cm (1/4 in.)tripods.• Firmly screw in the 4 screws.3 Attach the tripod.• Firmly screw in the tripod screw.Removing and Attaching the Grip UnitThe grip unit comes originally attached to the camcorder. You can remove it and replace it with the thumb restshould the minimal configuration be necessary.Removing the Grip Unit1 Set the Q switch to OFF.2 Unscrew the grip unit’s lock screw and gently detachthe grip unit.• The grip unit contains an internal connection cableso be sure not to pull it too forcefully.3 Disconnect the grip unit’s connection plug.4 Screw the thumb rest onto the camcorder.5.5 mmCOPY
