Adjusting the Focus80Remote Operation Using Wi-Fi RemoteAfter completing the necessary preparations (A 49), you can use the one-shot AF function remotely from aWi-Fi enabled device using the Wi-Fi Remote application.1 On the camcorder, set [~ Camera Setup] > [AF Mode] to [One Shot] (A 79).• This is only necessary when using a lens compatible with automatic aperture. For other lenses, [One Shot] isthe default setting and cannot be changed.2 Press [ONE-SHOT AF].• An AF frame appears at the center of the live view screen and the camcorder will focus automatically.• The AF frame turns green (correct focus) or red (when the camcorder cannot focus automatically) and thendisappears after a few seconds.# Continuous AFWhen a lens compatible with automatic aperture is attached to the camcorder, you can have the camcorderfocus automatically.1 Set the focus mode switch on the EF lens to AF (autofocus) inadvance.• [AF] will appear on the left of the screen.2 Open the [AF Mode] submenu.[~ Camera Setup] > [AF Mode]3 Select [Continu.] and then press SET.NOTES• About the autofocus (AF) functions:- One-shot AF is available for any EF lens equipped with autofocus (AF) function; Continuous AF is availableonly for lenses compatible with automatic aperture (A 192). Refer to the instruction manual of the lensused.- Autofocus (one-shot AF or continuous AF) is not available during slow & fast motion recording mode.- One-shot AF is not available when the shutter mode is set to [Slow] and the shutter speed is set to 1/4or 1/3.- The point where the camcorder focuses may change slightly depending on shooting conditions, such assubject, brightness and zoom position. Check the focus before resuming shooting.[~ Camera Setup][AF Mode][One Shot]COPY
