107Special Recording Modes• [INT STBY] changes to [Ü INT REC] while recording frames and [Ü INT STBY] while between intervals.4 Press the START/STOP button again to stop recording.• All of the recorded frames are joined together into one clip.• The tally lamps go out and [INT STBY] appears at the top of the screen (with [INT] flashing).NOTES• This special recording mode is not available when [w Other Functions] > [Bit Rate/Resolution] is set to[35 Mbps 1440x1080]. Also, you can use only one special recording mode at a time.• While recording, you cannot change the interval or number of frames.• Some frames at the point the recording was stopped may be recorded and added to the end of the clip.• Interval recording mode will be deactivated if the special recording mode is changed or turned off. It will bedeactivated also if you change the video configuration.• During this special recording mode, the running mode of the time code (A 84) can be set to [Rec Run] or[Regen.] and the time code advances by the number of frames recorded. If the running mode of the time codeis set to [Free Run] or the time code is input from an external source, the running mode will switch to [Rec Run]during special recording mode. When special recording mode is deactivated, the running mode will return toits previous setting.• During special recording mode, the time code signal will not be output from the TIME CODE terminal orHD/SD SDI terminal.Frame Recording ModeSet the number of frames in advance. We recommend operating the camcorder remotely or stabilizing thecamcorder, for example, on a tripod. Sound is not recorded in this mode.Configuring Frame Recording Mode1 Open the [Rec Frames] submenu.[w Other Functions] > [Frame Rec] > [Rec Frames]2 Select the desired number of frames and then press SET.• Available options depend on the frame rate used: 1, 3, 6 and 9frames (when [w Other Functions] > [24.00P] is set to [On] or[Frame Rate] is set to [23.98P], [29.97P] or [59.94i]), or 2, 6 and 12frames (when [w Other Functions] > [Frame Rate] is set to [25.00P],[50.00i], [50.00P] or [59.94P]).Activating Frame Recording Mode and Recording1 Open the [Special Rec] submenu.[w Other Functions] > [Special Rec]2 Select [Frame Rec] and then press SET.• [FRM STBY] appears at the top of the screen (with [FRM] flashing).3 Press the START/STOP button to begin recording.• The camcorder automatically records the set number of frames.• The tally lamp illuminates.• [FRM STBY] changes to [Ü FRM REC] while recording frames and [Ü FRM STBY] when frames are notbeing recorded.• Repeat until you finish recording.4 Open the [Special Rec] submenu.[w Other Functions][Frame Rec][Rec Frames][1][w Other Functions][ Special Rec][Off]COPY
