Configuring Connection Settings156Adding a New Connection Setting Using the WizardThis section uses a connection to a Wi-Fi network using the WPS push button method as an example. Refer tothe instruction manual of the access point for details about the location and operation of the WPS button.1 Select > [ Network Settings] > [Network] > [Enable] to enable the network functions.2 Select > [ Network Settings] > [New Conn. Setting (Wizard)] > Desired network function >[OK].3 Select [Create New Comm. Setting].• Once you have added multiple communication settings, you can select [Select Existing Setting] to reuse thesettings for a network that you saved previously.4 Select [Wi-Fi ].• To configure a wired (Ethernet) network, refer toEthernet Settings (A 160).5 Select [Connect with WPS] > [WPS (Push Button)].• To use a different configuration method, complete the corresponding procedure.Camera Access Point (A 160)WPS using a PIN code (A 161)Detected access points (A 161)SSID/authentication mode input (A 162)Manual setup without connecting to the network (A 162)6 Press and hold the WPS button on the wireless router and then, on the camera, select [OK].7 To configure the IPv4 settings automatically and not use IPv6 settings, select [Automatic Setting] >[Disable].• To configure IPv4 settings manually, continue with that procedure instead (A 164).• To use the default IPv6 settings, select [Enable] instead. After completing the wizard, change the IPv6settings as necessary (A 166).8 When the confirmation message appears, press SET to continue to configure the function settings.• The communication settings are saved to an [NW] file.• Continue with one the following procedures to configure the selected function’s settings.FTP transfer (A 157), IP streaming (A 158), Browser Remote (A 159)NOTES• The [WPS (Push Button)] method may not work correctly if there are several active access points in the area. Insuch case try using [WPS (PIN Code)] (A 161) or selecting one of the detected networks (A 161).
