Preparing the Handle Unit and LCD Monitor32NOTES• Based on the LCD monitor’s position, you can invert the image displayed on the screen. Repeatedly pressingthe MIRROR button will change the displayed image in the following order: Image inverted horizontally ´Image inverted vertically ´ Image inverted horizontally and vertically ´ Original image.• You can adjust the brightness, contrast, color saturation, sharpness and luminance of the LCD screen with therespective settings in the > [¢ Monitoring Setup] menu (A 183).• In CAMERA mode, you can use the > [¢ Monitoring Setup] > [B&W Image: VIDEO Term.] setting tochange the LCD monitor to black and white display. Even when the captured image is displayed in black andwhite, onscreen displays and icons will be shown in color.• You can use the > [B System Setup] > [Touch Screen Response] setting to adjust the LCD monitor’sresponse to touch input.Removing the LCD Monitor and LCD Attachment Unit1 Turn off the camera.2 Disconnect the unit cable from the camera’s andmonitor’s VIDEO terminals.• Pull back the metallic tip of the plug and thendisconnect the cable from the terminal.3 Loosen the locking knob and remove the LCDattachment unit and monitor.IMPORTANT• Be careful not to drop the camera when attaching orremoving the LCD monitor.NOTES• If the LCD attachment unit’s locking knob was fastenedvery tight, you may need to use the supplied hex wrenchfor 0.64 cm, 1/4" screws to loosen it.
