Checking the Ink Status with the Ink Lamps1. Make sure that the power is turned on, then, holding both sides of the paper outputtray, gently open it.2. Open the document cover, then open the ink cover.Replacing Procedure3. Check the ink lamp.Close the ink cover after checking the ink lamp status.Replacing ProcedureThe ink lamp is on.The ink tank is correctly installed.The ink lamp is flashing.Flashing slowly (at around 3-second intervals)...... RepeatsInk tank is running low. Prepare a new ink tank.Flashing fast (at around 1-second intervals)...... Repeats- The ink tank is installed in the wrong position.Or- The ink has run out.Make sure that the ink tank is installed in the correct position as indicated by the label on the printhead holder. If the position is correct but the lamp flashes, there has been an error and themachine cannot print. Check the error message displayed on the LCD.A Message Is DisplayedThe ink lamp is off.The ink tank is not installed properly or the function for detecting the remaining ink level isdisabled. If the ink tank is not firmly in place, make sure that the orange protective cap has beenremoved from the bottom of the ink tank, then press on the top of the ink tank until the ink tankclicks into place.If the ink lamp is still off after reinstalling the ink tank, there has been an error and the machinecannot print. Check the error message displayed on the LCD.A Message Is DisplayedNoteYou can also check the ink status on the computer screen.Checking the Ink Status from Your Computer
