Edit Accessible IP Address Screen/Add Accessible IPAddress ScreenNoteThis screen is not available depending on the printer you are using.The example screenshots in this section refer to the Add Accessible IP Address Screen.1. Specification Method:Select either Single Address Specification or Range Specification to add the IP address(es).Single Address SpecificationSpecify each IP address separately.Range SpecificationSpecify a range of successive IP addresses.2. IP Address:Enter the IP address of a computer or a network device to allow access when you selectedSingle Address Specification in Specification Method:.An IP address is expressed as four values ranging from 0 to 255.Start IP Address:Enter the first IP address in the range of addresses of the computers or network devices to allowaccess when you selected Range Specification in Specification Method:.An IP address is expressed as four values ranging from 0 to 255.End IP Address:Enter the last IP address in the range of addresses of the computers or network devices to allowaccess when you selected Range Specification in Specification Method:.An IP address is expressed as four values ranging from 0 to 255.NoteThe Start IP Address: must be a smaller value than the End IP Address:.3. Comment:Optionally enter any information to identify the device, such as the name of the computer.ImportantComments will be displayed only on the computer used to enter them.
