Advanced Guide > Changing the Machine Settings > Changing Machine Settings from Your Computer > Changing theMachine Operation ModeChanging the Machine Operation ModeThis function allows you to change the machine settings, as necessary.The procedure for configuring Custom Settings is as follows:Custom Settings1. Open the printer driver setup window2. Make sure that the machine is on, and then click Custom Settings on theMaintenance tabThe Custom Settings dialog box opens.NoteIf the machine is off or bi-directional communication is disabled, a message may appearbecause the computer cannot collect the machine status.If this happens, click OK to display the most recent settings specified on your computer.3. If necessary, complete the following settings:Prevent paper abrasionThe printer can increase the gap between the print head and the paper during high-density printingto prevent paper abrasion.Check this check box to use this function.Ink Drying Wait TimeYou can set the length of the machine rest time until printing of the next page begins. Moving theslider to the right increases the pause time and moving the slider to the left decreases the time.If the paper gets stained because the next page is ejected before the ink on the printed page dries,increase the ink drying wait time.Reducing the ink drying wait time speeds up printing.4. Transmit the settingsClick Send, and click OK when the confirmation message appears.After that, the machine operates with the modified settings.Page topPage 700 of 817 pagesChanging the Machine Operation Mode