Message Is Displayed 7-15Feed LimitProblem 1: You pressed on the operation panel to feed more media than allowed.Solution: Open the tray, then turn the roll holder manually to feed the extra media.Size UndetectedProblem 1: The media has shifted out of the correct load position, or the media iscurled.Solution: Set the media correctly. (Æ P.2-8, P.2-20)Problem 2: The printer interior is dusty or dirty.Solution: Open the upper cover and clean inside the printer. (Æ P.6-11)Remove Ink TankProblem 1: Right cover was closed without removing the ink tank.Solution: Remove the ink tank.Turn Power Off!!Problem 1: The tape inside the upper cover or the belt stopper have not been removed.Solution: Switch the printer off, open the upper cover, remove the tape and beltstopper, then press the Power button. (Æ Setup Guide)Problem 2: The printer has malfunctioned.Solution: Switch the printer off, then press and hold down the Power button for over3 seconds to switch the printer on again.Solution: If the message occurs again after switching the printer off and on, note themessage in the first line of the operation panel display, then call forservice.W-Ink Full SoonProblem 1: The waste ink tank is nearly full and requires replacing very soon.Solution: Printing can continue after this message is displayed. However, you shouldcall for service as soon as possible before a Service Call is issued.
