Canon i-SENSYS LBP5300 Series Service Manual

Also see for i-SENSYS LBP5300 Series: User guide User guide

Contents

Chapter 33-7F-3-47Proper alignment appears as shown in the picture below where theelongate holes of the gear [1] and [2] and the plate are aligned in astraight line.F-3-488) Attach the plate [1].- 3 screws [2]9) Tighten all the way the screw [3] that has been tightened halfway.F-3-493.1.7 Operation Panel Unit3.1.7.1 Preparation for Removing the Control Panel 0013-9925/ i-SENSYS LBP5360 / i-SENSYS LBP53001) Detach the rear cover. (page 3-1)[Removing the Rear Cover]2) Remove the fixing assembly. (page 3-25)[Removing the FixingAssembly]3) Detach the upper cover. (page 3-2)[Removing the Upper Cover]4) Detach the left cover. (page 3-1)[Removing the Left Cover]3.1.7.2 Removing the Control Panel 0013-9926/ i-SENSYS LBP5360 / i-SENSYS LBP53001) Remove the cable guide [1].- 1 claw [2]2) Disconnect the connector [3].F-3-503) Remove the control panel [1].- 2 screws [2]F-3-513.1.8 DC Controller PCB3.1.8.1 Before Removing the DC Controller PCB 0013-9928/ i-SENSYS LBP5360 / i-SENSYS LBP53001) Remove the fixing unit. (page 3-25)[Removing the Fixing unit]2) Remove the network board. (page 3-10)[Removing the NetworkInterface Board]3) Remove the rear cover. (page 3-1)[Removing the Rear Cover]4) Remove the upper cover. (page 3-2)[Removing the Upper Cover]5) Remove the right cover. (page 3-1)[Removing the Right Cover]6) Remove the left cover. (page 3-1)[Removing the Left Cover]7) Remove the video controller PCB. (page 3-8)[Removing the VideoController PCB]3.1.8.2 Preparation for Removing the DC Controller PCB0014-8698/ i-SENSYS LBP53601) Detach the rear cover. (page 3-1)[Removing the Rear Cover]2) Remove the fixing assembly. (page 3-25)[Removing the FixingAssembly]3) Detach the upper cover. (page 3-2)[Removing the Upper Cover]4) Detach the right cover. (page 3-1)[Removing the Right Cover]5) Remove the video controller PCB. (page 3-8)[Removing the VideoController PCB]3.1.8.3 Removing the DC Controller PCB 0013-9929/ i-SENSYS LBP5360 / i-SENSYS LBP53001) Disconnect all the connectors and flat cables [2] from the DC ControllerPCB [1].F-3-522) Remove the test print button guide [1].- 4 claws [2]