Chapter 33-10F-3-674) Remove the memory controller PCB [1].- 4 connectors [2]- 3 screws [3]F-3-683.1.11 Interface Controller PCB3.1.11.1 Removing the Network Interface Board 0014-4436i-SENSYS LBP53001) Remove the network interface board [1].- 2 screws [2]F-3-693.1.12 Duplexing Driver PCB3.1.12.1 Preparation for Removing the Duplexing DriverPCB 0014-5074/ i-SENSYS LBP5360 / i-SENSYS LBP53001) Detach the rear cover. (page 3-1)[Removing the Rear Cover]2) Remove the fixing assembly. (page 3-25)[Removing the FixingAssembly]3) Detach the upper cover. (page 3-2)[Removing the Upper Cover]3.1.12.2 Removing the Duplexing Driver PCB 0014-4987/ i-SENSYS LBP5360 / i-SENSYS LBP53001) Remove the duplexing driver PCB [1].- 6 connectors [2]- 1 screw [3]F-3-703.1.13 Low-Voltage Power Supply Assembly3.1.13.1 Preparation for Removing the Low-VoltagePower Supply PCB 0013-9920/ i-SENSYS LBP5360 / i-SENSYS LBP53001) Detach the rear cover. (page 3-1)[Removing the Rear Cover]2) Remove the fixing assembly. (page 3-25)[Removing the FixingAssembly]3) Detach the upper cover. (page 3-2)[Removing the Upper Cover]4) Detach the right cover. (page 3-1)[Removing the Right Cover]5) Detach the left cover. (page 3-1)[Removing the Left Cover]6) Remove the high-voltage power supply PCB. (page 3-11)[Removingthe High-Voltage Power Supply PCB]3.1.13.2 Removing the Low-Voltage Power Supply PCB0013-9921/ i-SENSYS LBP5360 / i-SENSYS LBP53001) Disconnect the 4 connectors [2] from the DC controller PCB [1].F-3-712) Free the cable from the cable guide [1].F-3-723) Detach the upper rear sheet metal [1].- 3 screws [2]
