Chapter 55-39T-5-21T-5-22D-HV-DEUse it to enter the offset value for the high-voltage D/A outputfor the DC controller PCB.adjustment range: -50 to 50 (default: 0)1TSPLY-ADJUse it to adjust the toner supply distribution (axial direction) forthe developing assembly.adjustment range: 1 to 5 (default: 3)2COPIER > ADJUST > DENSSub-item Description LevelDENS-ADJ Use it to adjust the density of images (copier/printer).Use it to correct the F-value table in the event of fading in a high-density area or fogging in an image.adjustment range: 1 to 9 (default: 5)- to decrease fading, increase the value.- to decrease fogging, decrease the value.If you have initialized the RAM on the DC controller PCB, enterthe value indicated on the service label.1COPIER > ADJUST > BLANKSub-item Description LevelBLANK-T Use it to enter the image leading edge non-image width.1adjustment range: 1 to 500 (default: 118)If you have initialized the RAM on the DC controller PCB orreplaced the PCB, enter the value indicated on the service label.BLANK-B Use it to enter the image trailing edge non-image width.1adjustment range: 0 to 2362 (default: 23)If you have initialized the RAM on the DC controller PCB orreplaced the PCB, enter the value indicated on the service label.COPIER > ADJUST > DEVELOPSub-item Description Level
