0000 There is an error in the communicationbetween the main controller PCB and theCPU of the DC controller PCB.- Check the connector for any fault inconnection.- Replace the DC controller PCB.- Replace the main controller PCB.E248 There is an EEPROM error.0001 An error has occurred at power-on. - Replace the EEPROM.- Replace the reader controller PCB.0002 An error has occurred at time of writeoperation.0003 An error has occurred at time of readoperation after write operation.E315 There is a fault in the image data.0007 There is a JIBIG encode error. - Turn off and then back on the power.000d There is a JBIG decode error.E400 There is an ADF communication error.0001 There is a check sum error. - Check the connector for any fault inconnection.- Replace the reader controller PCB.- Replace the ADF controller PCB.0002 There is a reception status error.0003 There is a reception interrupt error.E413 There is a fault in the ADF shift motor.0001 The output of the shift HP sensor isidentified as indicating open.- Check the connector for any fault inconnection.- Replace the sensor and motor inquestion.- Check the mounting condition of thearea around the cam.0002 The output of the shift HP sensor isidentified as indicating closed.E490 The ADF type is wrong.0001 The ADF is not of a supported type. - Replace the ADF with a supported type.E503 There is an error in the finisher internal communication (finisher).0002 There is an error in the communicationbetween the finisher and the saddle unit.- Check the connection between thesaddle stitcher controller PCB and thefinisher controller PCB.0003 There is an error in the communicationbetween the finisher and the punch unit.- Check the communication between thesaddle stitcher controller PCB and thefinisher controller PCB.E505 There is a finisher backup memory error (finisher).Code Description Remedy
